JVC VERBATIM CU-VD20 Copying Manual

IMPORTANT
Please read carefully before use.
1. Get ready a recommended disc
Please use the recommended discs stated below.
Using discs other than those recommended may cause problem when copying to the DVD
and when playing back the DVD.
Recommended discs
DVD-R
Brand JVC JVC
TDK
Verbatim
SONY
Caution
•
Only DVD-R and DVD-RW discs can be used.
•
DVD-R DL (single-sided double layer) discs can only be used for High definition Everio.
•
Recording and playback may not function properly if the recording side is scratched or dirty.
2. Set up each device before copying
Everio
Dedicated USB cable
3
1
Connect the USB cable
2
Turn on CU-VD20
After turning on the power, wait for approximately 20 seconds before
proceeding to step .
3
The burner may not function properly within this 20 seconds.
3
Turn on the Everio
4
Insert a new recommended disc into CU-VD20
Next, operate the Everio. Proceed to step 3.
Easy and correct way of copying to a DVD
DVD-R DL
DVD-RW
(single-sided double layer)
JVC
Verbatim
CU-VD20
1
2
3. Copy all images to the DVD
Perform operations on the Everio.
1
Confirm that the display on the right
appears on the Everio LCD screen.
2
Select "ALL SCENES"
1 Select
(move up and down)
3
Select "ALL"
1 Select
(move up and down)
4
Select "EXECUTE"
1 Select
(move up and down)
4
Wait for the "copy in progress" screen on the
right to disappear, then turn off the power and
disconnect the USB cable.
5
Exit
Note
•
There are other ways of copying which includes copying only the desired files.
For details, refer to the instruction manual of Everio.
(Everio LCD screen display)
2 Confirm
(press down)
2 Confirm
(press down)
2 Confirm
(press down)
"Copy in progress" screen
Confirm
(press down)
Copying completed!
CU-VD20
LYT1728-004A
0707MNH-SW-BJ1