Network Parameter - UTStarcom F3000 Getting Started

Menu -> WiFi
After accessing this option, enter the WPA-PSK key and press the left soft
key (Ok) to complete the operation.
Ensure that the WPA-PSK key consists of 8-63 ASCII characters or 64
hexadecimal characters
Activate
Select this option to connect to the AP according to the AP profile setting.
If the connection fails, the phone will try to connect to other AP profiles'
APs. If the phone fails to connect to all these APs and the Auto Scan
function is active, the phone will try to search and connect to another
available open AP. (Refer to "Auto Scan" on page 84)
4.7.2.2 Auto Scan
Menu WiFi WiFi Config Auto Scan
If the Auto Scan function is active, when the phone is switched on and
fails to connect to the APs specified in "AP Profile", the phone will do a
scan for available APs and try to connect to one open AP of these
scanned APs.
After accessing this option, select Enable or Disable to activate or
deactivate the Auto Scan function.
Note: If the phone fails to connect to all the specified and scanned
APs, the phone will periodically retry AP connections.
If the phone fails to register with the service network after the AP
connection, the phone will prompt you to try another AP.

4.7.3 Network Parameter

Menu WiFi Network Parameter
This option enables you to set network parameters:
84