Pipe Fitting - Mixing Valve; Overflow Pipe From Safety Valve; Temperature Adjustment - OSO Super S User Manual

Eng
Pipe fitting

Pipe fitting - mixing valve

Mixing valve:
The Super S is fitted
with an UX
valve.
The valve
is factory
fitted, simp-
ly adjust to
required angle
and tighten nut.

Overflow pipe from safety valve

-must be fitted in rooms where a gully is not available
Power cable
16
Vv Kv
360°
If the safety valve
is to be adjusted
the nut must first
be loosened. Al-
ways remember
to tighten nut
after adjustment.
Optional rearwards

Temperature adjustment

The water temperature from the water heater to
the taps is adjusted with wheel A.
Start by turning A fully counter-clockwise. Then
adjust to requested temperature according to
the diagramme below by turning A clockwise.
The water inside the unit will, regardless of valve adjustment,
maintain a temperature of approx. 75°C to prevent bacteria.
°C
75
70
65
60
55
50
45
40
35
30
25
0
UXT valve applies only to older models of the Super S.
SVK
9 bar
Power cable and/
or overflow pipe
3/4"R
(optional)
Overflow
pipe ø18
(not included)
Pull out
Optional
downwards
Power cable and/
or overflow pipe
(optional)
Subject to changes without notice
Hw Cw
45
Mixing valve
1 2 3
Bottom view
Spår
ø 15 mm pipe
Cu or PEX
w/approved fittings
Nut
Olive
-
1/2" R thread
Off
A
+ On
UXT
UX
Turns
clock-
4 5
wise
Adjustable feet
Overflow
straight
down
(optional)