Setting The Clock; Setting The Alarm - C. Crane CCRadio2 Instruction Manual

Getting Started

SETTING THE CLOCK

Please read this entire section carefully before you start. Set the
time with the radio off. You must go through the steps listed below
without stopping for more than 15 seconds at any given time or you will
have to start over. (Refer to page 5 for Button Identification.)
1) Press the Clock Set Button. The hour digit will flash.
2) Using the Up/Down Tuning Button, select the appropriate
hour digit and AM or PM.
3) Press the Clock Set Button again to select the minutes digits, the
minutes digits will flash. Use the Up/Down Buttons to adjust the
minutes to the appropriate time.
4) You must press the Clock Set Button again to complete the time
setting. This also sets the seconds to "00".

SETTING THE ALARM

There are two different alarm modes on the CCRadio 2. You can choose
to wake up to the radio or to a tone. You can set the alarm with the
radio on or off.
Press and hold the Alarm Button until you hear a beep and see one of
To set the type of alarm:
these symbols flashing on the display.
To wake with the radio: While Alarm is flashing on
the display, press the Clock Set Button until you see
the symbol shown to the right. When the alarm goes off the radio will
play the last station selected at the same volume level last set.
To wake with a multi level tone: While Alarm is flashing,
press the Clock Set Button until you see the symbol
shown to the right.
To shut off the alarm function: Press and hold the Alarm Button until
you hear a short beep and the alarm symbol disappears.
1) Press and hold the Alarm Button, the hour digit and Alarm
To set the alarm time:
symbol will flash.
2) Using the Up/Down Tuning Button, select the appropriate
hour.
3) Press the Alarm Button again. Use the Up/Down Tuning Buttons
to adjust the minute to the appropriate time.
4) Press the Alarm Button again to complete the alarm setting.
CCRadio 2 Page 9