C. Crane CCRadio2 Instruction Manual page 19

Radio Operation
S 2: T S
TEP O ET THE
1) Press the Timer/Set Button again until the word OFF, the hour digit
and TIMER flash on the display.
2) Use the Tuning Up/Down Buttons to set the hour. Again, verify that
the time is set correctly for AM or PM.
3) Press the Timer/Set Button again so the word OFF and TIMER and
the minutes, flash on the display.
4) Use the Tuning Up/Down Buttons to set the minutes.
S 3: T S
TEP O ET THE
1) Press the Timer/Set Button again to select your desired frequency.
The word TIMER and the memory preset will flash on the display.
Using the Band Button, select the appropriate band [AM, FM, Ham
(VHF) or WX]. Press the memory button 1-5 that corresponds with
your desired station.
2) You must Press the Timer/Set Button again to complete the
setup.
The timer will go ON and OFF at the same time and same station
every day until you turn the timer off or reprogram it.
If TIMER is showing on the display then the Timer is set. Press and hold
To Turn Off The Timer
the Timer/Set Button until you hear a short beep and the word TIMER
disappears from the display.
NOTES ON THE TIMER
The timer can be used to play your favorite program every day.
To stop the timer from going off every day press and hold the
Timer/Set Button until you hear a short beep the word TIMER
disappears.
Once the timer is programmed, you may use your radio as normal. If you
are using the radio during a "timed" operation, the radio will automatically
switch to the programmed station, and turn off at the programmed OFF
time.
The word TIMER flashes while the radio is playing in Timer Mode.
CCRadio 2
OFF TIME
F
REQUENCY
Page 19