Setting The Clock; Setting The Alarm - C. Crane CCRadio 2E Instruction Manual

Getting Started

SETTING THE CLOCK

Please read this entire section carefully before you start. Set the time
with the radio off. You must go through the steps listed below without
stopping for more than 15 seconds at any given time or you will have to
start over. (Refer to page 8 for Button Identification.)
1) Press the Clock Set Button and hold for two seconds then release.
The hour digit will flash.
2) Using the Up/Down Tuning Button,
digit and AM or PM.
3) Press the Clock Set Button again, then release. The minutes digits will
flash. Use the Up/Down buttons to adjust the minutes to the appropriate
time.
4) You must press the Clock Set Button again then release to complete the
time setting. This also sets the seconds to "00".

SETTING THE ALARM

There are two different alarm modes on the CCRadio2E. You can choose
to wake up to the radio or to a tone. You can set the alarm with the radio on
or off. If the radio is off, the beep volume is significantly reduced.
To set the type of alarm:
Press and hold the Alarm Button until you hear a beep and see one of
these symbols flashing on the display
To wake with the radio: While Alarm is flashing on the display, press
and release the Clock Set Button until you see the symbol.
When the alarm goes off the radio will play the last station selected at
the same volume level last set.
To wake with a multi level tone: While Alarm is flashing, press and
release the Clock Set Button until you see the
To shut off the alarm function: Press and hold the Alarm Button until you
hear a short beep and the alarm symbol disappears then release.
To set the alarm time:
1) Press and hold the Alarm Button for two seconds then release. The hour
digit and Alarm symbol will flash.
2) Using the Up/Down Tuning Button,
digit and AM or PM.
3) Press the Alarm Button again then release. Use the Up/Down Tuning
Buttons to adjust the minute to the appropriate time.
4) Press the Alarm Button again then release to complete the alarm setting.
Page 12
select the appropriate hour
then release.
symbol.
select the appropriate hour
CCRadio2E