Table of Contents
Advertisement
Changing Display Resolution
The primary output on Avaya 1030 defaults to 720p60 and will work with any 720p HDMI
display.
To change display resolution, navigate to Administrator Preferences : Appearance :
Displays and choose Display 1 Resolution. You can change the resolution to
1920x1080i60 or 1920x1080p30 and it will work with most 1080 HDMI displays. However,
some 1080p displays will not work with 1080p30 mode and the display may be blank. In this
case you must configure the display resolution from either the Avaya Video Conference
Phone 1000 (refer to "Configuring Display Output from Avaya Video Conference Phone
1000" on page 22) or from the web administration interface for the Avaya system (refer to
the Avaya Video Communications Systems Administrator Guide). Avaya recommends that
before you change the display resolution to 1920x1080p30, ensure that you can access the
Display 1 Resolution preference using one of these methods.
Note:
To access the web administration interface for the system, HTTP access must be
set to Enabled (the default) in Administrator Preferences : Security : General
and you must identify the IP address of the Avaya system. The IP address appears
in the upper right corner on the main page of the user interface.
Configuring a Second Display
If you installed a second display, you must configure it. From the main screen of the user
interface, press
Administrator Preferences : Appearance : Layout and choose Display 2 Layout, which,
by default is set to None. Choose Presentations + DVI-I Input to configure the second dis-
play. When configured, display 2 shows either DVI-I input or presentations (near and far
end) when a presentation is sent or received.
The following conditions apply when using two displays with Avaya 1030:
•
The presentation icon that appears on screen during a call to indicate that a near or far
end presentation is in progress appears in display 1. For a presentation sent from a far
end participant, the receiving presentation icon
display 1; for a presentation sent from the near end, the sending presentation icon
appears in the lower right corner of display 1.
•
Only presentation video or DVI-I input is supported for display 2. Background image and
color preferences that appear in User Preferences : Backgrounds and Administrator
Preferences : Appearance : Backgrounds are available for display 1 only. The user
interface appears only in display 1.
17
on the Avaya remote control to access the System Menu. Navigate to
appears in the upper left corner of
Avaya 1030 Installation Guide
Advertisement
Table of Contents
