Rip Setup Page; To Configure Dmz Settings - Zoom 5350 User Manual

Figure 20. Example of DMZ Host Page

To configure DMZ settings:

1
Enter the last byte of the LAN IP address of the PC or other device on your network that you
want to configure as a DMZ host.
2
Click Apply.
Note: If a specific PC is set as a DMZ Host, remember to set this back to "0" when finished with
the needed application, since this PC will be effectively exposed to the public Internet.
Note: You may need to assign your DMZ host a static IP address on your LAN to insure that it
will always be at that address.
RIP Setup
The RIP Setup page allows you to configure RIP (Router Information Protocol) parameters. RIP
automatically identifies and uses the best known and quickest route to any given destination address
to help reduce network congestion and delays.
RIP is a protocol that requires negotiation from both sides of the network (e.g. both the cable
modem/router and your service provider's CMTS (Cable Modem Termination System)). Your
service provider will normally set this up based on their knowledge of their CMTS settings.
To access the RIP Setup page:
1
Click Advanced in the menu bar.
2
Then click the RIP Setup submenu.
Figure 21 shows an example of the menu and Table 15 describes the items you can select.
51