When Setup Fails - Epson EB-1430Wi Installation Manual

Appendix
c
While holding down the [Menu] button on the remote control or the control panel, connect
the power cord to the projector
The status indicator and the power indicator turn blue, and the lamp indicator and the temperature
indicator turn orange.
When all of the projector's indicators turn on, release the [Menu] button. The indicators turn on for
approximately 75 seconds.
When all of the indicators start flashing, the settings are being written.
Caution
•
Do not disconnect the power cord from the projector while the settings are being written. If the power
cord is disconnected, the projector may not start correctly.
•
Do not disconnect the USB flash drive from the projector while the settings are being written. If the
USB flash drive is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the power indicator is lit blue.
When the power turns off, remove the USB flash drive.

When Setup Fails

Check
Are the lamp indicator and the tempera‐
ture indicator flashing orange quickly?
The batch setup file may be corrupt, or the USB flash drive may not
be connected correctly. Disconnect the USB flash drive, unplug and
then plug in the projector's power cord, and then try again.
77
Remedy