Battery Condition Meter; Cb Radio Wiring; Swr Adjustment; Aux. Start Switch - Winnebago Brave 30W Owner's Manual

WARNING
To prevent wiring damage, it is
essential when replacing the cables
on the battery, or when using a
"booster" battery, that the positive
post and the positive cable be
attached and the negative post and
negative cable be attached. The posts
are marked (+) plus and (-) minus. If
a "fast charger" is used while battery
is in the motor home, disconnect both
battery cables before connecting the
charger. Never attempt to charge or
boost a frozen battery.

BATTERY CONDITION METER

See related item under "Monitor Panel" in sec-
tion 8, Appliances.

AUX. START SWITCH

See section 2, Driving Your Motor Home for
information on Aux. Start Switch.
AUXILIARY BATTERY (Aux. Batt)
SWITCH
See section 2, Driving Your Motor Home, for
information on the Auxiliary Battery Switch.

CB RADIO WIRING

(Optional)
If your coach is pre-wired for CB radio instal-
lation, the wires are wrapped in clear plastic sus-
pended beneath the left side of the dash as shown.
ELECTRICAL SYSTEMS
CB Wires
(in plastic sheath)
Be sure to read the wire labels before install-
ing a CB radio. The labels contain important in-
formation and cautions.

SWR Adjustment

To adjust CB antenna SWR (standing wave
ratio), turn the adjusting ring of the antenna to
achieve lowest SWR reading. This procedure
will help optimize transmitting and receiving ca-
pabilities of the CB radio system.
SECTION 6
6-9