HP OmniBook 900 Service Manual page 33

Note: Do not put screws
in these two holes.
CPU connector
Reassembly Notes
Caution
Follow these precautions while installing the CPU module to prevent damage to the CPU
connectors:
• Place the CPU module on the connector carefully. Use the screw holes as a guide.
• Place your fingers on top of the CPU module above the left and right ends of the connector.
Do not push at other locations.
• Press firmly at the left end while holding down the right—until the left engages. Then press
down the right down while holding the left.
• Press firmly until the CPU module seats in the connector—you should feel a slight click.
Install or replace thermal pads on the heatsink that are missing or damaged.
Do not install screws in the middle area of the heatsink. The only screws in the CPU area are at
the four corners of the CPU module.
HP OmniBook 900
Figure 2-7. Removing the CPU Module
Screw, M2×5mm (8)
Heatsink
CPU module
Removal and Replacement 2-13