Manual Lift Bed Operation; Electric Lift Bed Operation - Ezgo 28806-G01 Owner's Manual And Service Manual

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
ravine. A misjudgment of distance or an unstable surface
could result in the vehicle falling backwards.
Before operating, check to ensure no one is behind the
vehicle.
!
gasoline vapor and cause an explosion.
Always place a gas can on the ground before filling.
Never fill a gas can in the bed of the vehicle. Static elec-
tricity is built up during the fueling process and could dis-
charge causing the gasoline vapor to ignite.

MANUAL LIFT BED OPERATION

!
not released during lifting or lowering procedure.
Severe injury could result if bed is released and traps
fingers or other body parts.
To lift the manual lift bed, pull back on the latch release
handle immediately behind the driver seat (Ref. Fig. 10
on page 5). Raise the bed using the handle on the side of
the bed.
Front of Vehicle
Ref Mbl 3
Fig. 10 Manual Bed Latch
The gas strut will assist in raising the empty loadbed and
will keep the bed raised (Ref. Fig. 11 on page 5).
Over time, the gas strut may allow the load bed
to slowly lower. If this condition is evident,
replacement of gas strut is required.
To lower the manual lift bed, grasp the bed handle and
lower the bed to the rest position. Be sure hands are
not trapped by the bed.
OPERATION AND SERVICE INFORMATION
Never fill a gas can in the
!
bed of a vehicle. Static
discharge could ignite
Exercise caution while
!
operating the manual lift
bed to ensure the bed is
Manual Load Bed Latch
Move Rearward to release
Owner's Manual and Service Guide
Ref Gss 1
Fig. 11 Gas Strut
TAIL GATE OPERATION
To open the tail gate, lift tail gate straight up with a sharp
upward pull to lift out of the closed position and pivot out
for open position. To remove the tail gate, remove the
side cables from the loadbed and open tail gate until it is
straight down, move tail gate panel straight up to remove
from pins and remove from the load bed. Reassemble in
reverse order.

ELECTRIC LIFT BED OPERATION

!
not snagged during lifting or lowering procedure.
Severe injury could result if bed is lowered and traps
fingers or other body parts.
The electric lift toggle switch is located on the driver side
of the front seat panel (Ref. Fig. 12 on page 5). Move the
toggle switch upward to raise the dump bed and down-
ward to lower the dump bed.
Ref Lbs 1
Fig. 12 Electric Lift Switch
Exercise caution while
!
operating the electric lift
bed to ensure clothing is
Page 5