Floor Protection; Stove Dimensions; Lighting; Air Settings - Stanley Aoife Installation And Operating Instructions Manual

FLOOR PROTECTION

When installing this heater on a combustible floor , a
floor protector, consisting of a layer of non-com-
bustible material at least 3/8" thick covered with 1/8"
sheet metal is required to cover the area under the
heater and extend to at least 18" at the front and 8"
to the sides and rear. This will provide protection
from sparks and embers which may fall out from the
door when stoking or fuelling. (See Fig.6)
Fig.7
125
450
Note: Dimensions stated are in millimetres and may be subject to a slight +/- variation.

LIGHTING

Check that all dampers and catches are operating
correctly and ensure that all flue connections are
thoroughly sealed.

AIR SETTINGS

The stove has three independent air controls.
1. The primary air control or spin valve. Rotate the
spin valve clockwise to close and anticlockwise to
open. See Fig.8
2. The secondary air control, this is located under
the base. See Fig.9
Fig.6

STOVE DIMENSIONS

450
Fig.8
7