Ferrari F430 Spider Owner's Manual page 24

If you make a mistake, turn the key to
position 0 and repeat the operation from
step 1.
1) Read the 5-digit electronic code found
on the CODE CARD.
2) Turn the ignition key to position II:
at this point, the CODE and
warning lights stay on.
3) Push and hold down the accelerator
pedal. After approximately 8 seconds,
the OBD warning light will go off.
Release the accelerator pedal and get
ready to count the number of times the
OBD warning light flashes.
4) Wait until the number of flashes is
equal to the first digit of your CODE
CARD, then push and hold down
the accelerator pedal until the
warning light goes off after about 4
seconds, then release the accelerator
pedal.
5) The OBD warning light starts flashing
again. When the number of flashes
is equal to the second digit of your
CODE CARD, push and hold down the
accelerator pedal.
6) Proceed in the same manner for the
remaining digits in the code on the
CODE CARD.
7) When the last digit has been entered,
hold the accelerator pedal down. The
OBD warning light illuminates for 4
seconds and then goes off; release the
accelerator pedal.
24
8) When the OBD
fast (for about 4 seconds) it confirms
that the procedure has been carried
out correctly.
9) Proceed with starting the engine by
pressing the ENGINE START
OBD
on the steering wheel.
If the OBD warning light remains on,
turn the key to position 0 and repeat the
procedure from step 1.
This procedure can be repeated an
unlimited number of times.
After an emergency start, it is advisable to
contact your Authorized Ferrari Dealer
as the emergency starting procedure must
be carried out each time the vehicle is
started.
OBD
Electronic alarm system
The electronic alarm system performs the
following functions:
- remote control for central door locking;
- perimeter surveillance, detecting when
the doors or lids are opened;
- car movement surveillance.
The engine immobilizer function is ensured
by the Ferrari CODE system, which is
automatically activated when the key is
removed from the ignition switch.
System activation
Press the radio control button
to activate the alarm system:
warning light flashes
button
- the direction indicators flash once
- the red LED
- the central door locking system is
activated and the doors are locked.
After about 25 seconds, the system is active
and the alarm will be triggered if:
- a door is opened
- the luggage compartment lid is opened
A on the key
- the engine compartment lid is opened
�
on the dashboard flashes
B
�