Appliance Checkout; Lighting Instructions - Lennox ELITE LDV42N Installation Instructions Manual

LENNOX HEARTH PRODUCTS • ELITE LINEAR VIEW DIRECT-VENT GAS FIREPLACE (MODELS LDV42, LDV54) • INSTALLATION INSTRUCTIONS
VERIfyINg APPLIANCE
OPERATION
With the gas line installed, run the initial
system checkout before closing up the front
of the unit.
Follow the pilot lighting instructions provided
in on the next page.
Note: Lighting instructions (and rating plate)
are also provided on a tag attached to one
of the lower door brackets.
When first lighting the appliance, it will take
a few minutes for the gas line to purge itself
of air. Once purging is complete, the pilot and
burner will light and operate as indicated in the
instruction manual.

Appliance Checkout

To light the burner, slide the wall switch to the
ON position (or use the remote control with the
wall switch in the REMOTE position.
Ensure the ignitor lights the pilot. The pilot
flame should engulf the flame sensor rod, as
shown in Figure 30-1.
30
Ignitor
Sensor
Figure 30-1
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
Pilot
Hood