Table of Contents
Advertisement
LENNOX HEARTH PRODUCTS • ELITE LINEAR VIEW DIRECT-VENT GAS FIREPLACE (MODELS LDV42, LDV54) • INSTALLATION INSTRUCTIONS
INSTALLINg fIREPLACE COMPONENTS
(CONTINUED)
INSTALL gLASS DOOR ASSEMBLy
1. While holding the door assembly by the
side edges, hook the top edge to the fire-
place, and then swing the bottom edge in
toward the fireplace, taking care not to
damage the glass (Figure 29-1).
2. Align the screw holes below the door
assembly with the holes in the fireplace,
and secure using the (3) provided screws.
Reverse these steps to remove the glass door
assembly.
WARNINg
hOT gLASS WILL CAUSE BURNS.
DO NOT TOUCh gLASS UNTIL COOLED.
• Remove glass door assembly only when
fireplace is Off and COLD.
• Do not attempt to touch the front enclo-
sure glass with your hands while the
fireplace is in use.
• The glass on the front of the fireplace
reaches ExTREMELy hIgh temperatures
and can cause severe burns if touched.
Even after the gas is turned off, fireplace
surfaces remain extremely hot.
CAUTION
RISk Of PERSONAL INjURy
OR PROPERTy DAMAgE.
• Do NOT abuse glass door by striking or
slamming shut.
• Handle glass with extreme care! Glass is
susceptible to damage; do NOT scratch or
handle roughly while reinstalling the glass
door frame.
• Never operate fireplace with glass door
assembly removed.
These direct-vent appliances are designed
to operate only when glass door assem-
bly is installed. Generally, the glass door
assembly should not be removed, except
when access to components within the
firebox is required.
• Do not attempt to substitute the materials
used on these doors, or replace cracked
or broken glass.
• The glass door(s) of this appliance must
only be replaced as a complete unit as pro-
vided by the manufacturer. Do not attempt
to replace broken, cracked or chipped glass
separately.
WARNINg
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou brisé.
INSTALL MODESTy PANEL
To install the modesty panel, attach the 3 hooks
to the slots in the door, and then slide it to the
LEFT until fully seated.
INSTALL OPTIONAL SURROUND
Install the surround after wall finish is com-
plete. See Pages 33 and 34.
Figure 29-1
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
glass Door Assembly
rating plate and lighting instructions
are attached to door bracket.
WARNINg
AVERTISSEMENT
29
Hide quick links:
Advertisement
Table of Contents
