Baffle Removal/Reinstallation - Lennox ELITE LDV42N Installation Instructions Manual

Elite series linear view direct-vent gas fireplace
Table of Contents

Advertisement

LENNOX HEARTH PRODUCTS • ELITE LINEAR VIEW DIRECT-VENT GAS FIREPLACE (MODELS LDV42, LDV54) • INSTALLATION INSTRUCTIONS
Reinstall baffle.
With the baffle oriented as shown in Figure
28-1, slide the rear tabs into the slots in the
back panel.
While sliding the tabs into the slots, slide the
front lip of the baffle under the clips in the
firebox ceiling.
Baffle
Figure 28-1
• The media was designed to provide a safe, reliable, attractive flame.
Any attempt to use media not specified for this fireplace will result
in incomplete combustion, sooting, and poor flame quality, and will
void the warranty.
• Media gets very hOT during fireplace use and will remain hot up to
ONE hOUR after gas supply is turned off. hANDLE MEDIA ONLy WhEN
COOL. Turn Off all electricity to the appliance before installing media.
• If media is not installed according to the installation instructions,
flame impingement and improper combustion could occur, resulting
in soot.
• This appliance is NOT designed to burn wood. Any attempt to burn
wood in this fireplace may be a safety hazard, cause irrepairable
damage to the appliance, and void the warranty.
28
Reinstall control compartment access
panel.
Reverse the steps shown under CONTROL
COMPARTMENT ACCESS on Page 12.
firebox Ceiling
Clip
Tabs
Back Panel
WARNINg
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite ldv42pElite ldv54nElite ldv54p

Table of Contents