Installing The Car Stereo; Final Check - Parrot Asteroid Quick Start Manual

Compare the Parrot ASTEROID antenna connector to the antenna connector of your vehicle. If an
adapter is necessary, contact your local car audio specialist. Make sure you also supply power
to your antenna if it is amplified. Power to the antenna can be supplied using the Parrot
ASTEROID ISO cable.

Installing the car stereo

1. Insert the cage and fix it into the dashboard using the bracket mounting tab.
2. Pull audio and power cables of the vehicle to the outside of the dashboard, through the
mounting bracket.
3. Connect the audio and power connectors of the Parrot ASTEROID to the ones of your vehicle.
4. Check the wiring (as explained in the Final check section).
5. Install the audio cables (as explained in the Installing the cables section).
6. Install the double microphone (as explained in the Installing the microphone section)
7. Slide the car stereo into the Parrot ASTEROID cage and install the faceplate.

Final check

Once all the connections are made, turn the ignition on then off to perform the installation test.
The "Goodbye" message must be displayed.
If it is not the case, it is necessary to swap the positions of the red and yellow wires. Indeed,
the red wire of the power cable must be connected to the 12V ignition, the yellow wire to the
permanent 12V and the black wire to the ground. This can be done simply by reversing both
fuse holders located on the Parrot wiring.
Installation
6
Example of antenna adaptor -DIN / Fakra (not provided)