Epson WF-5110 User Manual page 49

User's Guide
Menu Settings and Description
Menu List of Control Panel
PCL Menu Font Source
Font Number
Pitch
Height
Symbol Set
Form
CR Function
LF Function
Paper Source
Assign
49
Select the default font source.
Select the default font number for the
default font source. The available
number depends on the settings you
made.
Set the default font pitch if the font is
scalable and of fixed-pitch. You can
select from 0.44 to 99.99 cpi (characters
per inch), in 0.01-cpi increments. This
item may not appear depending on the
Font Source or Font Number settings.
Set the default font height if the font is
scalable and proportional. You can
select from 4.00 to 999.75 points, in
0.25-point increments.
This item may not appear depending
on the Font Source or Font Number
settings.
Set the default symbol set. If the font
you selected in Font Source and Font
Number is not available in the new
Symbol Set setting, the Font Source and
the Font Number settings are
automatically replaced with the default
value, IBM-US.
Set the number of lines for the selected
paper size and orientation. This also
causes a line spacing (VMI) change, and
the new VMI value is stored in the
printer. This means that later changes in
the Page Size or Orientation settings
cause changes in the Form value, based
on the stored VMI.
Set for using particular operating
systems, such as UNIX.
Set the assignment for the paper source
select command. When 4 is selected,
the commands are set as compatible
with the HP LaserJet 4. When 4K is
selected, the commands are set as
compatible with the HP LaserJet 4000,
5000, and 8000. When 5S is selected,
the commands are set as compatible
with the HP LaserJet 5S.