Lan Settings; Ip Settings - TANDBERG 8000 MXP User Manual

TANDBERG 8000 MXP User Manual

4.8.2 LAN Settings

LAN Settings contain:
 IP Settings
 H.323 Settings
 SNMP Settings

4.8.2.1 IP Settings

Remember to restart the system after making changes to IP Settings. Changes in IP Settings
menu will not have any effect before the system is restarted.
IP-assignment
DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is
present.
DHCP IP-address, IP-subnet mask and Gateway are not used because the DHCP
server assigns these parameters.
Static The system's IP-address, IP-subnet mask and Gateway must be specified in the
IP-address field.
IP-address
IP-address defines the network address of the codec. This address is only used in static
mode. In DHCP-mode, the assigned IP-address can be found on the Welcome Menu.
IP-subnet mask
IP-subnet mask defines the type of network. This address is only used in static mode. Your
LAN-administrator will provide the correct value for this field.
Gateway
When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP
addresses, IP address, subnet mask, and default gateway must be specified by the LAN
administrator.
Ethernet Speed
Auto The codec will auto-detect the speed/duplex on the LAN.
10/Half The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/Full
10 Mbps speed/Full Duplex.
104