TANDBERG 8000 MXP User Manual page 103

Example: 12345678*2 (up to four digit sub addresses are possible).
Validate Numbers / MSN (Multiple Subscriber Number)
The use of MSN (Multiple Subscriber Number) enables you to attach different ISDN terminals,
with different numbers, to the same physical ISDN telephone line. If Validate Numbers is set
to On only calls to those numbers specified in the Line Setup menus will be answered. This
service can be ordered from your telephone company.
Parallel dial
On Channels will be dialed and connected in parallel when setting up a BONDING
call.
Off Channels will be dialed one by one, which may increase the dialing time.
Send Own Numbers
On The system will send its own numbers to the far end.
Off The system will not send its own numbers to the far end, but please note that the
network may still send your numbers to the far end.
Sending Complete
On The system will send the ISDN message information element Sending Complete.
Off The system will not send Sending Complete.
4.8.1.2 ISDN-PRI Settings
To make sure your system will work properly using ISDN-PRI, configure the following
settings:
1. Set PRI switch type
2. Enter PRI line number
Note that the T1 format is predefined to ESF and the line code is B8ZS. This is not
configurable.
4.8.1.2.1 Number Range
Enter the range of numbers for your PRI line. If this number is programmed and MSN: On
(see Validate numbers in Advanced ISDN Settings) only calls to this number will be
answered.
4 Administrator Settings
99