TANDBERG 8000 MXP User Manual page 105

4.8.1.2.4 Line Settings
T1 Cable T1 Cable Length 1 specifies the distance to the CSU connected to the
Length 1
E1/T1 port 1 on codec 1.
T1 Cable T1 Cable Length 2 specifies the cascading distance from the E1/T1 port
Length 2 2 on codec 1 to the E1/T1 port 1 on codec 2. Possible values are 0-115
feet, 80-215 feet, 180-310 feet, 280-410 feet, 375-510 feet, 475-605 feet,
575-690 feet.
E1-CRC-4 is used for most E1-PRI configurations. You can turn it off if
E1-CRC-4 not supported by your E1 network equipment.
For further information see Appendix 3: Connecting the system to
PRI/T1.
4.8.1.2.5 Advanced ISDN-PRI Settings
NSF is a non standard facility. Your network provider may require a service selection in your
ISDN configuration. Enter the Service code here. Valid NSF service codes are from 1 to 31.
Enter 0 to disable NSF service codes.
Example:
AT&T offers several digital switched services. These include SDN with service code 1 and
ACCUNET with service code 6.
Below is a list of common service profiles. As these profiles may change, contact your
service provider to get the correct profile.
Service profiles for AT&T:
NSF Service
Disable
SDN (including GSDN)
Megacom 800
Megacom
Accunet
Long Distance
International 800
MultiQuest
Call Redirection Service
Service porfiles for Sprint:
NSF Service
0 Reserved
1 Private
2 Inwatts
3 Outwatts
6 FX
7 TieTrunk
8
16 Service profiles for MCI:
23 NSF Service
VNET/Vision
800
PRISM1, PRISMII, WATS
900
DAL
4 Administrator Settings
0
1
2
3
4
5
1
2
3
4
5
101