G7 4GÁ6A 89ÁU GS4@8ÁR8QU 68ÁF4GT4E
Q84QÁRTRI8GR HG
49
Insert the mounting bolts and thread on the nuts.
Figure 65 — Shock absorber installation
Using a 1/4" hex bit to keep the mounting bolts from
turning, tighten the nuts to specification with a 9/16"
socket and torque wrench.
Lower the motorcycle to the floor and remove the lift.
Apply blue threadlock to the three battery box mounting
screws. Place the battery box in position on the frame
and install the screws. Secure the wiring harness in
position against the battery box using new tie straps.
Install the battery following the procedures under
CHARGING SYSTEM SERVICE.
Install the rear fender, saddlebag brackets, rear engine
guard, saddlebags and seat following the procedures in
the FRAME AND ACCESSORIES SERVICE section.