Mechanical Instructions - Philips Rotary Mower Service Manual

Mechanical Instructions

8
V30 107B5
Go to cover page
http: / / j d wx z l w.5 d 6 d .com/ ? f r omuser=SN v Û ~ ô O î
0. General
To be able to perform measurements and repairs on the "circuit
boards", these unit should placed in the service position first.
1.Remove the rear cover in Fig. 1.
-Remove 2 screws as shown
-Remove back cover as shown
-Remove pedestal as shown
2. Video panel
- Disconnect the wire between metal shield of Video panel and
CRT neck as shown in Fig. 2.
- Disconnect the CRT ground from Video panel.
- Remove screw grounding and grounding wire in Fig. 3.
3.Main board connector in Fig. 4
-Disconnect york wire
-Disconnect rotation connector
-Disconnect control board connector
-Remove Screw for fixed I/F cable
-Remove signal connector
-Remove degaussing wire connector
screw - grounding
Fig. 3
Clip
Pedestal ass'y
Screw
Screw
Fig. 1
Degaussing wire connector
Control connector
Signal connector
Rotation connector
Fig. 4
CRT grouding wirel
[ ¶ u 5 ~ ô O î • De™•Q ÿ Q M •9 N •} T yÍ ~ ô O î • De™
Video Panel
Fig. 2