JVC GR-DVM801 Instructions Manual page 61

4 SET EDIT-IN POINT
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In
position appears in the LCD monitor and on
the connected TV.
5 SET EDIT-OUT POINT
At the end of the scene, press EDIT IN/OUT.
The Edit-Out position appears in the LCD
monitor and on the connected TV.
6
USE FADE WIPE ON SCENE TRANSI-
TION (IF NECESSARY)
Press FADE/WIPE.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•If you select a Fade/Wipe effect for an
Edit-Out point, the effect is automatically
applied to the following Edit-In point.
•When you use Fade/Wipe effects, that time is
included in the total time (this does not apply
to Picture Wipe/Dissolve).
7
USE P.AE/EFFECT (IF NECESSARY)
Press EFFECT.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•You can use Classic Film, Monotone, Sepia,
Strobe or Video Echo effects.
8 CONTINUE EDITING
Repeat steps 4 – 7.
•To change previously registered points, press
CANCEL on the remote control. The
registered points disappear, one at a time,
from the most recently registered point.
•If you're not using Fade/Wipe or P.AE/Effects,
repeat steps 4 and 5 only.
RM-V708U or
RM-V710U
(provided)
FADE/WIPE
EFFECT
EDIT IN/OUT
Remote sensor
Power Dial
T W
PLAY
R.A.EDIT ON/OFF
CANCEL
NOTES:
Before Random Assemble Editing, make sure the LCD
monitor indications don't appear on the TV monitor.
If they appear during Random Assemble Editing, they
will be recorded onto the new tape. To clear them,
set "ON SCREEN" to "OFF" (
Random Assemble Editing starts, its indications
disappear and are not recorded on the new tape.
When the source tape has more than 2 identical time
codes ( pg. 21), the camcorder may not find the
Edit-In point you chose and a malfunction may
occur.
When choosing a scene, set Edit-In and Edit-Out
points so there's a relatively large difference between
them.
If the search time for an in-point exceeds 5 minutes,
the recording deck's Record-Standby mode will be
cancelled and editing will not take place.
If there are blank portions before or after the
Edit-In and Edit-Out points, a blue-backed screen
may be included in the edited version.
Since time codes register time only as accurately as
seconds, the time code total time may not match the
total program time exactly.
Turning off the camcorder's power erases all
registered Edit-In and Edit-Out points.
If you use Sepia or Monotone P.AE/Effects, you can't
use the Dissolve or Black & White Fader. In this case
the Dissolve or Black & White indicator begins
blinking. Once the next Edit-In point is registered, the
effect is turned off. To combine these effects, use
Sepia or Monotone during recording, then use
Dissolve or Black & White Fader during Random
Assemble Editing.
Program
OUT
I N
: :
1 ~
2 ~
3 ~
4 ~
5 ~
6 ~
7 ~
8 ~
:
T I ME CODE
TOTAL
00 : 0 0
Random Assemble Editing Menu
pg. 43). When
CONTINUED ON NEXT PAGE
61
EN