JVC GR-DVM801 Instructions Manual page 53

1
CONNECT DOCKING STATION TO
TV OR VCR
Connect as shown in the illustration
( pg. 52, 53).
2 TURN ON POWER
3 SELECT TV'S VIDEO MODE
Set the TV to the channel or mode appropriate
for video playback.
If Using A VCR . . . go to step 4.
If not . . . go to step 5.
4 CONNECT VCR OUTPUT TO TV
INPUT
Refer to your VCR's instruction manual.
5 START PLAYBACK
Press play and your pre-recorded scenes will
be played on your TV.
6 END PLAYBACK
Press STOP and, if you're not going to
continue using the camcorder, set the Power
Dial to "OFF".
NOTES:
To change from normal to slow-motion playback,
press PAUSE at the point where you want to start
playback in slow motion, then point the remote
control at the Docking Station's sensor and press
SLOW (Rewind/Forward). After playing back in
slow motion for about 10 to 20 seconds, normal
playback resumes. Speed is 1/10 times normal. To
stop slow-motion playback in progress, press
PLAY.
During slow-motion playback, due to digital
image processing, the picture may take on a
mosaic effect.
After SLOW is pressed, the still image may be
displayed for a few seconds, then the screen may
become blue back for a few seconds.
There may be a small margin between the slow-
motion playback start point you chose and the
start point at which the camcorder actually begins
playback in slow motion.
When using the provided AUDIO/VIDEO cable
(Docking Station to TV or VCR), DC cord,
S-VIDEO cable or editing cable, make sure you
connect the end of the cable with the core filter to
the Docking Station. The core filter improves
performance of equipment.
53
EN