Yamaha DKC-850 Operation Manual page 20

1
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
2
Disconnect the control cable from the TO CONTROL
CABLE FOR PIANO connector on the rear panel of your
control unit.
Loosen the two screws attached to the connector by the
screwdriver.
3
Connect the supplied conversion cable to the control
cable disconnected in step 2.
Tighten the two screws attached to the connector by the
screwdriver.
4
Connect the supplied conversion cable to the TO PIANO
connector on the rear panel of the Disklavier control unit.
Tighten the two screws attached to the connector by the
screwdriver.
5
Connect monitor speakers to the OUTPUT jacks on the
rear panel of the Disklavier control unit.
6
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of the Disklavier control unit.
7
Connect the supplied power cable to the AC adaptor.
8
Connect the power cable extended from your piano and
the AC adaptor to the AC wall outlet.
The connection completed.
Turn on the Disklavier control unit, and set the piano type.
Getting Started
Note:
The location of the TO CONTROL
CABLE FOR PIANO connector
varies depending on the piano
model.
Important:
Please keep the disconnected control
unit for future maintenance.
See Chapter 2 "Getting Started –
Connecting Monitor Speakers" on
page 12.
See Chapter 2 "Getting Started –
Setting the Type of Your Piano" on
page 15.
Chapter
2
9