Lubrication; Greasing The Machine - Toro Greensmaster 04052 Operator's Manual

Lubrication

Greasing the Machine

Service Interval: Every 25 hours
Lubricate the 13 grease fittings on the mower using
a No. 2 multipurpose lithium base grease. A hand
operated grease gun is recommended for best results.
The grease fitting locations are as follows:
• 2 on the front roller (Figure 14)
• 2 on the reel bearings (Figure 14)
• 2 on the drum axles (Figure 15)
• 3 on the differential (Figure 15)
• 2 on the reel countershaft bearings (Figure 16)
• 2 on the belt idler pivots (Figure 17).
1. Wipe each grease fitting with a clean rag._
2. Pump grease into each fitting until it begins to get
difficult to pump the gun.
Important: Do not apply too much pressure or
grease seals will become permanently damaged.
3. Wipe off excess grease.
Figure 14
Figure 15
21
Figure 16
Figure 17