Installing The Kickstand (Model 04060 Only) - Toro Greensmaster 04052 Operator's Manual

5. Squeeze the handle ends inward and install them on
the mounting pins (Figure 3).
1. Handle end
6. Secure the handle ends to the mounting pins with the
bolts, washers, and lockwashers previously removed
(Figure 3).
7. Secure the bottom of handle arms to each side of
the mower with the bolts and locknuts previously
removed (Figure 3). Ensure that you install the
bushings in the handle arm mounting holes.
8. Secure the handle arms to the rear of the frame with
the hairpin cotters and ring pins previously removed
(Figure 3).
9. Secure the cables to the handle with cable ties
(Figure 4).
1. Cable tie
Adjusting the Handle
1. Remove the hairpin cotters from the ring pins on
each side of the mower (Figure 2).
Figure 3
Figure 4
2. While supporting the handle, remove the ring pins
from each side and raise or lower the handle to the
desired operating position (Figure 2).
3. Install the ring pins and hairpin cotters.
2
Installing the Kickstand (Model
04060 Only)
Parts needed for this procedure:
1 Kickstand assembly
1 Spring
Procedure
Note: The fasteners are shipped loosely installed on the
kickstand assembly.
1. Hook spring into hole in spring bracket and onto
spring retainer while aligning kick stand with
mounting holes in rear frame (Figure 5).
1. Kick stand
2. Spring bracket
2. Mount the kick stand to each side of the frame with
a bolt, lockwasher, spacer, flat washer and locknut
(Figure 5). Position the spacer in the kick stand
mounting hole.
11
Figure 5
3. Spring retainer
4. Spring