Hitachi DZ-GX20A Service Manual page 42

Troubleshooting > Messages and Troubleshooting
Message
Use AC adapter/charger.
Use AC adapter/charger.
Turn off power.
VIDEO scene cannot be
copied to card.
Write protected.
Check disc.
Write-protected.
Check card.
Note:
The listed messages are subject to change without notice for improvement of performance.
Cause/condition for
message to appear
Appears if a battery is used when
finalizing a DVD-R. The specifications
state that DVD-R can be finalized only
when the AC adapter/charger powers the
DVD video camera/recorder.
Appears if a battery is used when
repairing video files. The specifications
state that video files can be repaired only
when the AC adapter/charger powers the
DVD video camera/recorder.
Appears if an attempt is made to copy
video to card. The specifications state
that no video is unrecordable on card.
Appears if a DVD-RAM that was write-
protected for disc units by software disc-
protect function is loaded, or if an
attempt is made to record on write-
protected disc.
Appears when an SD memory card
whose erasure prevention switch was
locked is loaded.
4 - 17
Troubleshooting
Terminate the Disc Navigation
function, set the power switch to
"OFF" with the disc loaded, remove
the battery, and then connect the AC
adapter/charger: Finalize the disc
again.
Set the power switch to "OFF" with
the disc loaded, remove the battery,
and then connect the AC adapter/
charger.
[Refer to *3 page 4-11]
Stop trying to copy a video, or select
photos and execute copy.
Release the software disc-protect.
Unlock the erasure prevention switch
of SD memory card.