Hitachi DZ-GX20A Service Manual page 38

Troubleshooting > Messages and Troubleshooting
Message
Disc includes protected
scenes.
Delete scenes?
YES NO
Disc is full.
Cannot add control info.
Disc is not formatted.
Format the disc now?
YES NO
Disc is not formatted.
If it formats, it becomes
possible to use for camera.
However, when you record
from PC connection
terminal, please do not
format.
Format the disc now?
YES NO
*4: The purpose of formatting DVD-R on the DVD video camera/recorder is to write to disc a program
exclusively for camera recording that is necessary to record images shot by camera in real time
(increasing the response from disc). When recording images that were edited using PC on DVD-R via the
PC connection terminal, do not format the disc: The program used exclusively for camera recording will
disable normal recording.
Cause/condition for
message to appear
Appears if the loaded disc has a program
(scene) that is write-protected by the
software write-protect function, which is
effective in program units. Although the
DVD video camera/recorder is equipped
with a software disc-protect function that
is effective for disc units, it does not
comply with software write-protect for
program units. (The DVD Forum defines
two types of software protect for DVD-
RAM: disc units and program units.)
Appears when the card contains a scene
write-protected by a device other than
this DVD video camera/recorder.
Appears if the number of scenes on play
list exceeds the upper limit (999) while
control information is being added.
[Refer to *1 page 4-8]
Appears when reading or writing from/to
recorded file cannot be performed
because the disc is dirty.
Appears when an unformatted DVD-
RAM or one initialized (other UDF2.0)
on PC is loaded.
Also appears if user rejects partial repair
or total repair of video file.
Appears when a brand-new DVD-R was
loaded.
4 - 13
Troubleshooting
Release the write-protect using the
device that has the software write-
protect function for program units, or
choose "YES" and designate it to
delete the scenes.
Release the write-protect using the
device which set it. Or choose "YES"
and delete the scene.
Delete any unnecessary scenes, or
combine several scenes, and then
operate the DVD video camera/
recorder.
Refer to "4-4-4 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
When initializing it (deleting all
recorded data), choose "YES" and
designate it.
Choose "NO" and designate partial
repair or total repair. When
initializing it (deleting all recorded
data), choose "YES" and designate it.
When recording on the DVD video
camera/recorder, choose "YES" and
designate it. When recording video
edited on PC connected via the PC
connection terminal, choose "NO" and
designate it.
(*4)