Hitachi DZ-GX20A Service Manual page 37

Troubleshooting > Messages and Troubleshooting
Message
Disc error has occurred.
Finalizing is not complete.
Disc error has occurred.
Format the disc now?
YES NO
Disc error has occurred.
Formatting is not complete.
Disc error has occurred.
Keep disc inside & restart.
Disc full.
Cannot execute.
Disc has no data.
Disc has no Play List.
Cause/condition for
message to appear
Appears when the disc could not be
finalized because it was dirty.
Appears if accident, such as power off,
has occurred during finalizing.
If the message still appears even when
the disc has been cleaned and finalized
again and again, the disc may be
defective.
Appears when reading or writing from/to
recorded file cannot be performed
because the disc is dirty.
Appears when a DVD-RAM initialized on
PC, etc., or a card whose initialization
was suspended before, is loaded.
Appears when the disc could not be
normally formatted because it was dirty.
Also appears when a warped or distorted
disc was loaded, or a logically damaged
disc whose formatting was suspended is
loaded.
Appears if a problem has occurred during
editing of video file.
Appears if the recording capacity of disc
has reached the limit during editing of
video file.
Appears when playback or editing is
attempted using the Disc Navigation
function with no scene recorded on disc.
Appears if switching of play list is
selected with no play list registered.
4 - 12
Troubleshooting
Refer to "4-4-4 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Set the power switch to " OFF" and
reconnect the AC adapter/charger;
then set the power switch to "VIDEO"
and start finalizing again. Or press
the DISC EJECT button, reload the
disc, and then execute finalizing.
Replace the disc.
Refer to "4-4-4 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Choose "YES" and designate it to
initialize the DVD-RAM (deleting all
recorded data).
Refer to "4-4-4 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Replace the disc.
Exit the Disc Navigation function and
set the power switch to "OFF" with
the disc loaded; then reconnect the
AC adapter/charger and set the
power switch to "VIDEO" or "DISC
PHOTO". (The DVD video camera/
recorder will automatically repair the
video file.)
Delete unnecessary scenes, or replace
the disc.
Operate the DVD video camera/
recorder after the message
disappears.
Operate the DVD video camera/
recorder after the message
disappears.