Hitachi DZ-GX20A Service Manual page 39

Troubleshooting > Messages and Troubleshooting
Message
Disc overheat.
Please retry later.
DVD-R Disc, 16:9 mode
cannot be changed when
Video mode is STD
DVD-R Disc, Input Source
cannot be changed.
DVD-R Disc , Video mode,
16:9 mode cannot be
changed.
END OF DISC
End scene cannot be divided.
Error occurred.
Please replace disc or format
disc
Error occurred.
Please replace disc.
Finalize may not be
complete.
Finalize again now?
YES NO
Cause/condition for
message to appear
Appears when the temperature inside
the DVD video camera/recorder, or the
temperature of disc, is too high, and
normal operation cannot be executed.
Appears when the wide-screen mode was
chosen with the video quality set to STD
using a DVD-R: The combination of STD
(352 × 480 pixels) and wide-mode is
prohibited by the DVD video format.
Appears when an attempt was made to
switch the input with a DVD-R recorded
in wide mode: Only the 4:3 aspect screen
is possible for external input.
This is because the DVD video format
prohibits the mixing of 16:9 and 4:3
aspect screens.
Appears when an attempt was made to
change the video quality or wide mode of
recorded DVD-R. This is because, if even
one scene is recorded after a disc is
formatted, the specifications state that
the video quality or wide mode used for
the first recording will be held on the
DVD-R.
Appears if the disc recordable capacity
has reached the limit during recording.
Appears when the last image of scene
was selected to divide the scene: The
specifications state that dividing a scene
at its end is not possible.
Also appears when reading or writing
from/to recorded file cannot be performed
because the disc is dirty.
Appears if repair has failed with DVD-
RAM after message "Data error in all
image file. Repair all data now?" or
"Found error in image file. Repair data
now?" appeared.
Appears if repair has failed with DVD-R
after message "Data error in all image
file. Repair all data now?" or "Found
error in image file. Repair data now?"
appeared.
Appears if accident, such as power off,
occurred during finalizing, and then
power was turned on again or disc was
reloaded.
4 - 14
Troubleshooting
Set the power switch to "OFF" with
the disc loaded, and then leave the
DVD video camera/recorder in a well-
ventilated place until the inside
temperature decreases.
Change the video quality to XTRA or
FINE when using a brand-new DVD-
R. If the DVD-R has already been
recorded in STD mode, replace it.
Stop trying to switch the input, or
replace the disc.
Stop trying to change the video
quality or wide mode, or replace the
disc.
Replace the disc.
Stop trying to divide a scene.
Refer to "4-4-4 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Initialize the disc (deleting all
recorded data), or replace the disc.
Replace the disc.
Choose "YES" and designate it to
finalize the disc.