Installation; Control Panel - Honeywell 7000 Product Data

INSTALLATION

When Installing this Product...
1. Read these instructions carefully. Failure to follow them
can damage the product or cause a hazardous condition.
2. Check the ratings given in the instructions and marked
on the product to make sure the product is suitable for
the application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out the product
operation as provided in these instructions.
Overview
This section provides a general overview of the system
(Fig. 1) and installation and hookup instructions for the
following equipment:

1. Control Panel:

a. Enclosure.
TELCO
LINES
RJ31X
J1
TB1
BATTERY
CONTROL PANEL
HBUS
RF TRANSMITTERS
RF RECEIVER
Fig. 1. General overview of Honeywell System 7000.
HONEYWELL 7000 SOLID STATE ALARM SYSTEM
b. Circuit Board.
c. Transformer.
2. Point Expansion Module.
3. RF Expansion Module.
4. RF Receiver.
5. RF Transmitter.
6. Keypad.
Control Panel
The control panel performs the main functions of the system.
The following can be found inside the control panel
enclosure:
a. Control Panel Circuit Board.
b. Batteries.
PLUG-IN
TRANSFORMER
HORN/BELL
S1
SMOKE
DETECTOR
HARDWIRE LOOPS
1 2 3 MODES
FIRE
4 5 6
OPTIONS
POLICE
7 8 9
OK
SPECIAL
0
CANCEL
KEYPAD
POINT
EXPANSION
MODULE (PEM)
HARDWIRE LOOPS
RF EXPANSION
MODULE (RFEM)
3
M10907
69-1192—1