Log Placement; Ph18-R - MHSC PH18 Installation And Operating Instructions Manual

PH Gas Logs
The positioning of the logs are critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are not
properly and firmly positioned in the appliance. Never add additional logs or
embellishments such as pine cones, vermiculite or rock wool to the heater.
Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use
only parts specifically approved for this heater may result in property damage
or personal injury.
PLACE PH18-R LOGS
1. Place Rear Log (#1) on rear support.
Figure 16.
2. Place Left Middle Log (#2) on middle
support and burner. Figure 17
3. Place Right Middle Log (#3) on middle
support. Figure 17
NOTE: Logs #1, #2 and #3 have ridges on
the bottom which secure the logs to burner
frame. After installing each log, check to be
sure it is stable.
Left Middle Log #2
LG1085
16
Rear Log #1
Figure 16
Right Middle Log #3

LOG PLACEMENT

D O N O T s p r i n k l e
volcanic rock on the
logs or around the pilot
or the main burner. This
may cause sooting.
LG1084
Only place volcanic
PH18 rear log 1
rock on the floor of the
fireplace.
During initial operation
o f t h e n e w h e a t e r,
burning logs will give off
a paper burning smell
and orange flames will
be present. Simply open
the windows for a few
hours to vent the odor.
Figure 17
LG1084
65D2035