Recording Menus - JVC GR-D270 Instructions Manual

MENUS FOR DETAILED ADJUSTMENT
32
EN

Recording Menus

The "m CAMERA" settings are effective when
the Power Switch is set to both "A" and "M".
However, the menu settings can be changed
only when the Power Switch is set to "M".
[ ] = Factory-preset
REC MODE
[SP]: To record in the SP (Standard Play) mode
LP: Long Play—more economical, providing 1.5
times the recording time.
NOTES:
Audio Dubbing (
( pg. 46) are possible on tapes recorded in the
SP mode.
If the recording mode is switched, the playback
picture will be blurred at the switching point.
It is recommended that tapes recorded in the LP
mode on this camcorder be played back on this
camcorder.
During playback of a tape recorded on another
camcorder, blocks of noise may appear or there
may be momentary pauses in the sound.
SOUND MODE
[12BIT]: Enables video recording of stereo
sound on four separate channels, and is
recommended for use when performing Audio
Dubbing. (Equivalent to the 32 kHz mode of
previous models)
16BIT: Enables video recording of stereo sound
on two separate channels. (Equivalent to the
48 kHz mode of previous models)
ZOOM
25X: When set to "25X" while using digital zoom,
the zoom magnification will reset to 25X since
digital zoom will be disengaged.
[100X]*: Allows you to use the Digital Zoom. By
digitally processing and magnifying images,
zooming is possible from 25X (the optical zoom
limit), to a maximum of 100X digital
magnification.
800X*: Allows you to use the Digital Zoom. By
digitally processing and magnifying images,
zooming is possible from 25X (the optical zoom
limit), to a maximum of 800X digital
magnification.
* Available only when the VIDEO/MEMORY Switch
is set to "VIDEO".
CAMERA
pg. 46) and Insert Editing
SNAP/SLOW
[FULL]: Snapshot mode with no frame
NEGA: Nega mode
PIN-UP: Pin-Up mode
FRAME: Snapshot mode with frame
SLOW: Live Slow mode
[FULL] NEGA
For details on the procedure, refer to "Live Slow"
( pg. 37) and "Snapshot (For Video
Recording)" ( pg. 38).
GAIN UP
OFF: Allows you to shoot dark scenes with no
picture brightness adjustment.
[AGC]: The overall appearance may be grainy,
but the image is bright.
AUTO : The shutter speed is automatically
adjusted. Shooting a subject in low or poor
lighting at slow shutter speed provides a brighter
image than in the AGC mode, but the subject's
movements are not smooth or natural. The
overall appearance may be grainy. While the
shutter speed is being automatically adjusted,
" " is displayed.
The "q MANUAL" settings are effective only
when the Power Switch is set to "M".
[ ] = Factory-preset
DIS
OFF: Disables the function.
[ON ]: To compensate for unstable images
caused by camera-shake, particularly at high
magnification.
NOTES:
Accurate stabilisation may not be possible if hand
shake is excessive, or depending on the shooting
condition.
The " " indicator blinks or goes out if the
Stabiliser cannot be used.
Switch off this mode when recording with the
camcorder on a tripod.
PIN-UP FRAME
MANUAL