Table of Contents
Advertisement
Recording Menus
The "m" settings are effective when the Power Switch is
set to both "A" and "M". However, the menu settings can
be changed only when the Power Switch is set to "M".
[ ] = Factory-preset
REC MODE
[SP]: To record in the SP (Standard Play) mode
LP: Long Play—more economical, providing 1.5 times
the recording time.
NOTES:
● Audio Dubbing (
pg. 30) and Insert Editing (
possible on tapes recorded in the SP mode.
● If the recording mode is switched, the playback picture will
be blurred at the switching point.
● It is recommended that tapes recorded in the LP mode on
this camcorder be played back on this camcorder.
● During playback of a tape recorded on another camcorder,
blocks of noise may appear or there may be momentary
pauses in the sound.
SOUND MODE
[12 bit]: Enables video recording of stereo sound on four
separate channels, and is recommended for use when
performing Audio Dubbing. (Equivalent to the 32 kHz
mode of previous models)
16 bit: Enables video recording of stereo sound on two
separate channels. (Equivalent to the 48 kHz mode of
previous models)
ZOOM
16X: When set to "16X" while using digital zoom, the
zoom magnification will reset to 16X since digital zoom
will be disengaged.
[40X]: Allows you to use the Digital Zoom. By digitally
processing and magnifying images, zooming is possible
from 16X (the optical zoom limit), to a maximum of 40X
digital magnification.
900X: Allows you to use the Digital Zoom. By digitally
processing and magnifying images, zooming is possible
from 16X (the optical zoom limit), to a maximum of 900X
digital magnification.
SNAP MODE
[FULL]: Snapshot mode with no frame
PIN-UP: Pin-Up mode
FRAME: Snapshot mode with frame
[FULL]
PIN-UP
For details on the procedure, refer to "Snapshot (For
Video Recording)" (
pg. 24).
CAMERA
pg. 30) are
FRAME
MENUS FOR DETAILED ADJUSTMENT
GAIN UP
OFF: Allows you to shoot dark scenes with no picture
brightness adjustment.
[AGC]: The overall appearance may be grainy, but the
image is bright.
AUTO
: The shutter speed is automatically
adjusted. Shooting a subject in low or poor lighting at
slow shutter speed provides a brighter image than in the
AGC mode, but the subject's movements are not smooth
or natural. The overall appearance may be grainy. While
the shutter speed is being automatically adjusted, "
is displayed.
The "q" settings are effective only when the Power
Switch is set to "M".
[ ] = Factory-preset
DIS
OFF: Disables the function.
[ON
]: To compensate for unstable images caused
by camera-shake, particularly at high magnification.
NOTES:
● Accurate stabilisation may not be possible if hand shake is
excessive, or under the following conditions:
• When shooting subjects with vertical or horizontal stripes.
• When shooting dark or dim subjects.
• When shooting subjects with excessive backlighting.
• When shooting scenes with movement in various
directions.
• When shooting scenes with low-contrast backgrounds.
● Switch off this mode when recording with the camcorder on
a tripod.
● The "
" indicator blinks or goes out if the Stabiliser
cannot be used.
TELE MACRO
[OFF]: Disables the function.
ON: Usually the distance to a subject where the lens is in
focus depends on the zoom magnification. Unless there
is a distance more than 1 m to the subject, the lens is out
of focus at the maximum telephoto setting. When set to
"ON", you can shoot a subject as large as possible at a
distance of approx. 60 cm.
NOTE:
Depending on the zoom position, the lens may go out of
focus.
MANUAL
19
EN
"
Advertisement
Table of Contents
