The Cyberview Workplace; Cyberview Menus; Scan Menu - Reflecta DigitDia 5000 User Manual

The Thumbnail Panel only appears when Pre-scan is selected for the first time (section 6.3). It can
be dragged anywhere on the desktop, i.e. outside the Cyberview Preview window. On my
installation, the Close function is disabled, i.e. after the first Pre-scan, the Thumbnail Panel is
always displayed when Cyberview is active.
If Cyberview cannot be started for any reason, the following error message is usually displayed.
Check the first two items and ignore the third – the User Manual will not help.
JS recommends:
•
The scanner should be directly connected to the PC (i.e. not via a hub).
•
Always use the originally supplied cable – cables which are too long can cause problems.
•
Turn off the scanner and PC.
•
Restart the PC and wait until it has booted up completely.
•
Switch on the scanner.
•
Start Cyberview.

5.2 The Cyberview Workplace

This section gives an overview of the Menus, Toolbar and Toolbox in a convenient reference
format, listing each function and sub-function. Certain simple functions are described here, but
detailed descriptions are given in Scanner Operations – section 6.
5.2.1
Depending on the Cyberview mode (e.g. pre-scan), certain entries may be greyed out.

5.2.1.1 Scan Menu

•
Pre-scan – see section 6.3.
•
Scan – see section 6.5.
•
Revert - see section 6.3.7
•
Preference – see section 6.1.2.
•
Exit – close down Cyberview – see section 6.8.
Cyberview

Cyberview Menus

Page 7 of 33 Dec 2008