HYOSUNG XRX125sm Owner's Manual page 65

◉ ◉ FUSE
The fuse holder is located inside the right
side cover.
If the engine suddenly stops while running
or any electrical system fails to operate then
the fuse must be checked.
In case a fuse blows there is a 15A spare
fuse.
Check the fuse with the ignition switch
"OFF" .
1. Remove the right side cover.
2. Take out the fuse holder.
3. Open the fuse holder and take out the
fuse.
FUSE
CAUTION
Never use other than specified 15A fuse.
Installing a fuse of incorrect rating may
seriously damage the electrical system.
You should consult your Hyosung
dealer or a qualified service mechanic
immediately.
FUSE HOLDER
FUSE CONNECTOR
WHEN THE ENGINE REFUSES
TO START
◉ ◉ TROUBLE SHOOTING
If the engine refuses to start, perform the
following inspections to determine the cause.
● ● Fuel Supply Check
①
Is there enough fuel in the fuel tank?
②
Is the fuel reaching the carburetor from
the fuel cock?
③
Disconnect the fuel line from the
carburetor, turn the fuel cock to the "ON"
position and see if gasoline flows from
the hole.
④ If it has been determined that fuel is
reaching the carburetor, the ignition
system should be checked next.
Do not allow the fuel to spill.
Catch the fuel in container.
Do not allow any fuel to come in contact
with the hot engine or exhaust system.
Extinguish any smoking materials
before performing this check, and stay
away from any other fire or heat source.
● ● Ignition System Check
①
Remove a spark plug and reattach to the
spark lead.
②
While holding the spark plug firmly against
the crankcase of the engine, push the
starter switch with the ignition switch in the
"ON" position, the engine stop switch in
the " " position, the transmission in
neutral and the clutch disengaged.
If the ignition system is operating
properly, a blue spark should jump a
cross the spark plug gap.
③
If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug or
new one.
64
CAUTION