Table of Contents
Advertisement
•
Remove all packing material before using your cooler. Check to be sure all parts are included and
that the cooler is in good condition.
•
Clean the interior surface with lukewarm water using a soft cloth before first use.
•
Position the cooler in a dry and airy place. The recommended ambient temperature should be
between 50° and 80°F.
•
Place your cooler on a solid, level surface (other than carpet). This will ensure vibration and noise-
free operation.
•
When positioning the cooler, 6 inches of space at the back and 10-12 inches of space both sides are
suggested to ensure proper air circulation to cool the cooling system. There also must be unlimited
clearance at the top of the cooler to ensure proper air circulation.
•
Upon plugging the cooler into an electrical outlet, let the unit run for at least 30 minutes before making
any adjustments.
•
This wine cooler uses thermoelectric refrigeration technology (no compressor) and is not designed for
storage in hot areas like garages, warehouses or outdoors since it is designed to operate at a
maximum of 30 degrees below the ambient temperature.
•
The unit is designed for freestanding installation only. It is not designed to be installed under a
counter, inside a cabinet, or in any location that does not allow the proper clearances on all sides, as
stated above.
OPERATING YOUR WINE COOLER
The wine cooler has an electric temperature control panel and two temperature zones. When first turned
on, the LCD will show the ambient temperature, followed by the internal cabinet temperature.
The upper zone temperature can be set between 45° and 65°F. The lower zone can be set between 45°
and 65°F. Pressing the "UP" button on the control panel will increase the temperature by 1°F and
pressing the "DOWN" button will lower it. Upon choosing your desired temperature, the display will flash
the selected temperature setting for 5 seconds before reflecting the current internal cabinet temperature.
The "LIGHT" button turns the interior light on or off. The C/F button alternates the temperature reading
between Celsius and Fahrenheit.
8
INSTALLATION
W W W . V I N O T E M P . C O M
Advertisement
Table of Contents
