Table of Contents
Advertisement
Installing the IP Camera
•
•
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Warning
This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source
or an IEC60950 compliant limited power source. Statement 353
Note
This equipment is only to be connected to PoE networks without routing to outside plants.
For PoE input connection, use only UL listed I.T.E. with PoE output.
Installing the IP Camera
This section describes how to install the IP camera on a ceiling or wall.
Before you begin
•
Cisco Video Surveillance 6050 IP Camera Installation Guide
2-2
Do not touch the IP camera during a
lightning storm.
Do not drop the IP camera.
Use the screwdriver for tamper-proof screws that is provided with the IP camera to detach the dome
cover from the camera base as shown in
Do not put sharp or tiny objects into the IP
•
camera.
Figure
2-1.
Chapter 2
Camera Installation
OL-31413-01
Advertisement
Table of Contents
