Completing The Installation - Cisco 6050 Installation Manual

Chapter 4 Camera Management
Table 4-2
Field
Primary DNS
Secondary DNS
Stream 1 and Stream 2
User
IP Address
Start Time
Elapsed Time
Adjusting the IP Camera Viewing Angle and Focus and

Completing the Installation

To adjust the IP camera viewing angle and focus and complete the installation of the IP camera, perform
the following steps. For information about viewing video, see
Procedure
Step 1 Log in to the IP camera.
The Home window appears.
While viewing video in the Home window, take these actions to adjust the viewing angle:
Step 2
a.
OL-31413-01
Home Window Information (continued)
Description
IP address of the primary DNS server, if configured for the IP camera.
IP address of the secondary DNS server, if configured for the IP camera.
IP camera user name of each user who is accessing the primary video stream
(Stream 1) or the secondary video stream (Stream 2) through a client PC or
a third-party device.
Be default, users appear in order of start time. To displays users in ascending
order of any information in any corresponding column, click the column
heading. Click a column heading again to reverse the display order.
IP address of the client device.
Time and date that the client accessed the video stream for this session.
Length of time that the client has been accessing the video stream.
Loosen the two screws on the sides of the lens module, as shown in the following figure.
Do not remove the screws.
Adjusting the IP Camera Viewing Angle and Focus and Completing the Installation
"Viewing Live Video" section on page
Cisco Video Surveillance 6050 IP Camera Installation Guide
4-7.
4-3