Health O Meter 2500KL User Instructions page 8

2500KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Note: Do not attach the AC adapter power cord into the back of the display assembly at this
point.
14. Align the four mounting holes on the back of the display assembly with the four mounting
holes in the display support, and fasten the display assembly onto the metal display support.
Use the (4) Phillips pan head M4 screws (Screw "C" in Figure 1).
15. Place the pivot bracket screw covers over the pivot screws, and fasten the covers to the
back of the display assembly using the (4) Phillips pan head M4 screws (Screw "C", Fig. 1).
16. Attach the adapter holder to the left side of the handrail using the two (2) #8 x ½ sheet
metal screws (Screw "B" in Figure 1).
17. Connect the AC adapter to the power port, located on the back of the display assembly.
Caution: Do not plug the scale into a power source until the scale is fully assembled.
18. Rotate the display to align it parallel to the handrail. Attach the front and rear display
support covers by applying light pressure while snapping the covers into place.
19. The scale is now assembled. Plug the AC adapter into a power source and/or insert the
batteries.
8