Health O Meter 2500KL User Instructions page 15

2600KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Ramp Assembly Instructions
1. Follow these instructions for moving the ramp to the opposite side of the scale, or for
adding a second ramp to the scale (B2600RAMP option):
2. On the side of the platform opposite to the ramp, remove the guardrail mounted to the
end of the platform by unscrewing and then removing the 4 guardrail assembly screws.
3. Fold the ramp onto the platform surface.
4. Remove the screws attaching the 2 rubber bumpers, located on the side of the platform
(see Figure 8).
5. Remove the bumpers, and re-install them on the opposite side of the platform. Use the
appropriate mounting holes (see Figure 8).
6. Loosen the screws holding each ramp holder to the platform.
7. Remove the ramp from the ramp holders, and then remove the ramp holders by pulling
out on them slightly.
8. Install the ramp holders at the opposite side of the platform, but do not tighten the
screws.
9. Insert the ramp between the ramp holders, and tighten the assembly screws.
10. Install the guardrail on the opposite side of the platform.
Note: It is necessary to make small clearance holes in the mat in order to re-install the
guardrail assembly screws (the mounting holes are located beneath the mat). Use an awl
or small Phillips screwdriver to make the holes. Use the guardrail as a guide to locate the
two holes beneath the mat.
Note: A second ramp is available separately as B2600RAMP.
Figure 8
15