Health O Meter 2500KL User Instructions page 7

2500KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the 2500KL Scale (see Figures 2-5)
Caution: It is recommended that the assembly be performed by two persons.
1. Place scale base assembly on a flat, level, and dry floor.
2. Locate and pick up the handrail, and then find the load cell cable tucked inside.
3. Untie the load cell cable, and carefully pull the load cell cable end out the handrail bottom.
4. Position the handrail over the handrail mounting holes, located at the edge of the scale
base assembly (see Figure 2).
5. Feed the cable through the large center hole of the handrail mounting holes (located on the
right side of the "Health o meter" logo). Be sure not to pinch the cable.
6. Fasten the handrail to the base assembly using the eight (8) M8 1.25 x ¾ screws (Screw
"A" from Figure 1), eight (8) M8 washers (D), and the included 5mm Allen wrench.
Caution: Do not over-tighten the screws.
7. Pull forward on the handrail to tip the scale over, and gently place it face down on the
Caution: Take care to hold the ramp down when moving the scale-the ramp can flip
open when the scale is tipped
8. Grasp the load cell cable protruding from the bottom of the base assembly and feed it
through the protective metal shield. Plug the cable end into the load cell port (see Figure 3).
9. Pull the excess cable through the top of the handrail.
10. Thread the 4 feet into the underside of the base assembly. Each foot should initially be
completely hand tightened, and then backed out 1-½ full turns. This will allow for proper load
cell operation and scale accuracy (see Figure 4).
11. Carefully tilt the scale back to an upright position on the floor.
Caution: Take care to hold the ramp down when moving the scale-the ramp can flip
open when the scale is tipped
Warning: Do not drop the scale on its feet. This can result in permanent load cell
damage.
12. Adjust the feet to level the scale. Be certain that the feet are not completely tightened
into the base assembly (refer to the scale base-feet assembly instruction above).
13. Rotate the display support so that it is perpendicular to the handrail (see Figure 5). Then
position the display assembly close to the display support. Plug the load cell cable connector
into the load cell port on the rear of the display assembly. The port is labeled "LOAD CELL".
forward.
back.
floor.
7