Sharp SL-6000L Manual page 87

2. Performing a Reset
When a Reboot cannot be performed, or the Zaurus does not work correctly even
when rebooted, try the following reset operation (reset and full-reset). Editing data
will be lost by performing a reset (the stored data won't be lost).
Resetting
1.
After saving any entry being edited, close all applications.
Turn the Zaurus off and make sure that the screen has gone blank.
When the screen does not go blank after approximately 10 seconds or when the
power cannot be turned on/off, perform the next step.
2.
Press the reset switch with the supplied stylus pen.
3.
Turn the Zaurus on.
The Set System Time screen will be displayed after a few minutes.
Adjust the time and date, then press the OK key.
The Home screen will be displayed.
Full-resetting
Attempt a full-reset if the Zaurus does not work correctly even after performing a
reset.
1.
After saving any entry being edited, close all applications.
Turn the Zaurus off and make sure that the screen has gone blank.
When the screen does not go blank after approximately 10 seconds or when the
power cannot be turned on/off, perform the next step.
Appendix
Reset switch
85