Table of Contents
Advertisement
®
B
AG I
LACKHEAT
NSTALLATION
SECTION 1: HEATER SAFETY
Your Safety is Important to Us!
This symbol is used throughout the manual
to notify you of possible fire, electrical or burn
hazards. Please pay special attention when
reading and following the warnings in these
sections.
Installation, service and annual inspection of heater must
be done by a registered installer/contractor qualified in
the installation and service of gas-fired heating
equipment.
Read this manual carefully before installation, operation
or service of this equipment.
This heater is designed for heating nonresidential indoor
spaces. Do not install in residential spaces. These
instructions, the layout drawing, local codes and
ordinances, and applicable standards that apply to gas
piping, electrical wiring, venting, etc. must be thoroughly
understood before proceeding with the installation.
Protective gear is to be worn during installation, operation
and service. Thin sheet metal parts, such as the reflector
portion of the heater and the various venting
components, have sharp edges. To prevent injury, the use
of work gloves is recommended. The use of gloves will
also prevent the transfer of body oils from the hands to
the surface of the reflector.
Before installation, check that the local distribution
conditions, nature of gas and pressure, and adjustment of
the appliance are compatible.
The heater must be applied and operated under the gen-
eral concepts of resonable use.
This appliance is not intended for use by persons (includ-
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they do no
play with the appliance.
For additional copies of the Installation, Operation and
Service Manual, please contact Roberts-Gordon Europe
Limited.
1.1 Manpower Requirements
To prevent personal injury and damage to the heater, two
persons will be required for installation.
1.2 IP55 Protection
The burner is certified to protection class of IP55. This
means that the internal components of the burner are
protected against extreme dusty atmosphere and water
jets from all sides. Outside air supply and flue are
mandatory for this heater. The standard exhaust fans
mentioned in this manual do NOT have IP55 protection
and must be outside the wet environment. If the fan is to
be installed in the wet environment, a special IP54
protected fan must be used. Consult Roberts-Gordon
LLC for alternative exhaust fans. Optional stainless steel
burner box provides long life in the most corrosive
applications. Always ensure that the environment to be
heated is not of an explosive or flammable nature. For
2
O
S
M
PERATION AND
ERVICE
ANUAL
more information, please consult your ROBERTS
GORDON
®
representative.
In order to have trouble free performance of your
BLACKHEAT
®
AG heater and maintain the IP55
protection, follow all instructions in this manual, especially
the replacement of sealing gaskets.
1.3 Safety Labels and Their Placement
Product safety signs or labels should be replaced by
the product user when they are no longer are
legible. Please contact Roberts-Gordon LLC or your
ROBERTS GORDON
®
obtain replacement signs or labels. See Page 3,
Figure 1 through Page 3, Figure 2.
independent distributor to
Advertisement
Table of Contents
Troubleshooting
