Roberts Gorden AG15ST Installation, Operation & Service Manual page 27

Step 6.6.1 Reflector, U-clip and Reflector Support Installation
The pictorial drawings of the heater construction in
Section 6 are schematic only and provide a general
guideline of where hangers, reflector supports and
u-clips are to be installed.
To ensure proper expansion and contraction movement of
the reflectors, a combination of u-clips and reflector
Description
Reflector Support Package
Wire Form
Reflector Support Strap
Screw #8 x 3/4
U-clip Package
Reflector End Cap
Part Number
03050011
91908004
03050000
94320812
91107720
027508XX
SECTION 6: L & D
INEAR
supports are used. The positioning of reflector supports
and u-clips depend on the individual installation. Use
either pop rivets or sheet metal screws instead of u-clips
when installing end caps and joint pieces in areas where
impact and high wind may be a factor. The following rules
must be observed:
L H I
OUBLE INEAR EATER NSTALLATION
21