Rear Panel - Steinberg UR44 Operation Manual

Rear Panel

[ ] (Standby/On) switch
Sets the power of the device to On ( ) or Standby ( ).
CAUTION
Even when the [ ] switch is in the standby
position, electricity is still flowing to the unit. If you
do not plan to use the unit for a while, be sure to
unplug the AC power adaptor from the outlet.
NOTICE
• Setting the [ ] switch to on and standby in rapid
succession can cause it to malfunction.
• After setting the [ ] switch to standby, wait for
about six seconds before setting it to on again.
NOTE
When setting the [ ] switch to standby, the settings on the
Scene (page 11) and [PHONES 2] output signal are saved to
the device settings. Please note that the settings are not
saved if you turn the power off by disconnecting the power
cable when the [ ] switch is on.
DC IN [12V]
For connection to the AC power adaptor.
[USB 2.0] port
For connection to a computer or iPad. Apple iPad
Camera Connection Kit or Lightning to USB Camera
Adapter are required when connecting the UR44 with
an iPad.
USB Port Precautions
NOTICE
Be sure to observe the following points when
connecting to the computer's USB interface.
Failing to do so may result in the computer
freezing or shutting down, as well as corruption
or even loss of data. If the device or computer
does freeze, restart the application or computer.
• Be sure to wake the computer from
sleep/suspended/stand by mode before
making a connection to the computer's USB
port.
• Before turning on the power to the device,
connect the computer to the USB port.
• Before turning on/off the device or
plugging/unplugging the USB cable, quit any
open application software on the computer.
• When connecting or disconnecting the USB
cable, be sure to set all output level controls to
the minimum.
• Wait at least six seconds between connecting
or disconnecting the USB cable.
[CC MODE] switch
Turns the Class Compliant mode on and off. Make sure
to turn the [CC MODE] switch on when connecting the
device to an iPad. Also, make sure to turn the
[CC MODE] switch on before turning on the
[ ] switch. The Class Compliant mode will not change
if the [CC MODE] switch is turned on after the
[ ] switch has been turned on.
Description of the Device
UR44 Operation Manual 7