Rear Panel - Steinberg UR816C Operation Manual

Rear Panel

1 2
1 DC IN [16V]
For connection to the AC power adaptor.
2 [USB 3.0] port
For connection to a computer or iOS device.
NOTICE
When connecting to a computer with a [USB 3.0] port,
observe the following to prevent the computer from freezing
or shutting down, as well as corruption or even loss of data.
• Before connecting/disconnecting the USB cable, be sure to
observe the following points.
- Quit all open software applications on the computer.
- Set all output level controls to the minimum.
• Wait at least six seconds between connecting/
disconnecting the USB cable.
Apple accessories may be required when connecting the
UR816C with iOS devices. For details, refer to the UR816C
Startup Guide.
3 [WORD CLOCK IN] jack
[WORD CLOCK OUT] jack
For connection (via BNC cable) to a device that transmits
or receives word clock signals.
4 [OPTICAL IN] jack
[OPTICAL OUT] jack
For connection (via optical cable) to a digital audio
device. The optical jack is switchable between ADAT and
S/PDF format. To switch the format, use the "Hardware
Setup Window" (page 16) in the section "Dedicated
Windows for Cubase Series" or the "Setup Window"
(page 12) in the section "dspMixFx UR-C." To select the
output signal, refer to the "Setup Window"
section "dspMixFx UR-C."
5 [MIDI IN] jack
[MIDI OUT] jack
For connection to a MIDI device. Connect the MIDI OUT
jack of the MIDI device to [MIDI IN], and the MIDI IN jack
of the device to [MIDI OUT].
• Select [Steinberg UR816C-port1] for the MIDI port when using
a MIDI jack with an iOS app. Please note that [Steinberg
UR816C-port2] is not available.
• Do not activate dspMixFx when using a MIDI device. This may
interfere with stable data transmission/reception.
3 4 5
(page 12) in the
6 7
6 [MAIN OUTPUT L/R] jacks
For connection to monitor speakers. This outputs one of
the MIX 1to 4 signals. To adjust the output signal level, use
the [OUTPUT] knob on the front panel. These jacks can
be connected to phone-type (balanced/unbalanced)
plugs.
7 [LINE OUTPUT 1L/1R to 4L/4R] jacks
For connection to external devices with line level signals.
This outputs any stereo output. To select the output signal,
refer to "Setup Window" (page
"dspMixFx UR-C."
8 [MIC/LINE INPUT 5 to 8] jacks
For connection to a microphone or digital instrument. This
jack can be connected to both XLR-type and phone type
(balanced/unbalanced) plugs. The XLR type is set to the
optimum level for microphone connection and phone type
is for line connection.
The phantom power will be supplied to the XLR jack connected
to the [MIC/LINE 5 to 8] jacks.
Panel Controls and Terminals
8
12) in the section
UR816C Operation Manual 5